Bar Billiards Table Pocket Hole Rings

These hole rings are mould in the UK.  They are not 3D printed.

They are profiled interanally to suit Jelkes, SAM's or other makes of table and available in four sizes of outside diameter. The internal shape is the same for all sizes.

Unlike others rings available elsewhere, these are supplied with the retaining grooves for if you intend to fix them in place with plaster of paris or similar.

It is best practice to fix the rings in with plaster of paris otherwise they will gradually slip down into the slate leaving the edge of the cloth and slate unprotected causing accelerated cloth, ball and slate wear.

Having said that, they can be supplied without the grooves and in shorter height if so required.

The standard colour is as per the photos, but, other colours can be made at a cost and subject to a minimum quantity. Email me if interested.

Due to the manufacturing process, the colour shade may vary from batch to batch but each set of 9 rings will be the same colour.

Available in  62mm, 63mm, 64mm and 65mm outside diameters.

Sold in sets of 9 rings.

All dimensions are approximate.

To decide which size you need it is best to measure the inside diameter of the hole in the slate (without cloth) and allow 1mm less for a tight fit after the cloth is fitted. This is when using Hainsworth Match cloth. Other cloths maybe thicker so a smaller pocket might be required to obtain the best fit.

e.g. if holes in slate measures 65mm then I'd recommend a 64mm diameter pocket using Hainsworth Match cloth.